The Micro-Node RTCM and VOTER interfaces are typically used with AllStar in voting/simulcast applications. They MAY be used for ANY repeater interface application, through the chan_voter channel driver. The VOTER is the original through-hole board designed by Jim Dixon for this application. It is open-source, and the relevant Gerber files and BoM to build it are available. The [http://www.micro-node.com/thin-m1.shtml Micro-Node Radio Thin Client Module (RTCM)] is the commercial version of the VOTER. It uses surface mount parts (SMT), but is functionally equivalent to the original VOTER. In general, the two terms (RTCM/VOTER) are used interchangeably, as they operate the same, and use the same firmware (mostly, see below). | The Micro-Node RTCM and VOTER interfaces are typically used with AllStar in voting/simulcast applications. They MAY be used for ANY repeater interface application, through the chan_voter channel driver. The VOTER is the original through-hole board designed by Jim Dixon for this application. It is open-source, and the relevant Gerber files and BoM to build it are available. The [http://www.micro-node.com/thin-m1.shtml Micro-Node Radio Thin Client Module (RTCM)] is the commercial version of the VOTER. It uses surface mount parts (SMT), but is functionally equivalent to the original VOTER. In general, the two terms (RTCM/VOTER) are used interchangeably, as they operate the same, and use the same firmware (mostly, see below). |