Changes

Node names are in format of ''usb_<nodenumber>''.  Where <nodenumber> = the AllStar Link node of your system.  ''Note that usb and the node number are separated by an underscore (_) character.''

Node names are in format of ''usb_<nodenumber>''.  Where <nodenumber> = the AllStar Link node of your system.  ''Note that usb and the node number are separated by an underscore (_) character.''

Example:<p>

===Example===

Your simpleusb.conf file defines your usb radio as '''[usb_1000]'''.  Your rpt.conf file would then have:

Your simpleusb.conf file defines your usb radio as '''[usb_1000]'''.  Your rpt.conf file would then have:

==Parallel Port Pin Numbers==

==Parallel Port Pin Numbers==

Additional note on parallel port pin numbers:

'''Additional notes on parallel port pin numbers.'''

When you are looking at the '''pp#''' addressing, the actual hardware pin numbers are in computer natural logical format.<br>

When you are looking at the '''pp#''' addressing, the actual hardware pin numbers are in computer natural logical format.<br>

It is a coil and susceptible to absorbing RF and there is no quicker way to lock a computer up than to bugger this input/output with a stray signal.

It is a coil and susceptible to absorbing RF and there is no quicker way to lock a computer up than to bugger this input/output with a stray signal.

==Final Note==

===Final Note===

If you think you might be adding a Doug Hall RBI-1 Remote base later, Start populating pins 'above' pp3 reserving the 1st 3 pins.

If you think you might be adding a Doug Hall RBI-1 Remote base later, Start populating pins 'above' pp3 reserving the 1st 3 pins.

Check command tables for info, not related to simple_usb.conf.

Check command tables for info, not related to simple_usb.conf.

[[Category:Node Configuration]]

[[Category:Node Configuration]]