Difference between revisions of "RX Toneburst"
Jump to navigation
Jump to search
(Updated formatting) |
m |
||
| Line 1: | Line 1: | ||
| + | |||
[[Category:How to]] | [[Category:How to]] | ||
Setting Up Receive Toneburst Access (Europe mainly) | Setting Up Receive Toneburst Access (Europe mainly) | ||
Latest revision as of 05:51, 6 September 2021
Setting Up Receive Toneburst Access (Europe mainly)
If you wish to set up a node to require receive toneburst (typically 1750 Hz, in Europe), you must, at least specify the toneburst frequency:
(The following parameters go into rpt.conf in the section for the desired node)
rxburstfreq=1750
If you wish to change the minimum duration of the tone:
rxbursttime=500 ;this would set the minimum time to 500ms
If you wish to change the minimum signal/noise ratio for the tone:
rxburstthreshold=10 ;this would set the minimum s/n quality to 10db