Difference between revisions of "RX Toneburst"
Jump to navigation
Jump to search
m Tag: visualeditor |
m |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | ||
[[Category:How to]] | [[Category:How to]] | ||
| + | Setting Up Receive Toneburst Access (Europe mainly) | ||
If you wish to set up a node to require receive toneburst (typically 1750 Hz, in Europe), you must, at least specify the toneburst frequency: | If you wish to set up a node to require receive toneburst (typically 1750 Hz, in Europe), you must, at least specify the toneburst frequency: | ||
(The following parameters go into rpt.conf in the section for the desired node) | (The following parameters go into rpt.conf in the section for the desired node) | ||
| − | + | <syntaxhighlight lang="text"> | |
rxburstfreq=1750 | rxburstfreq=1750 | ||
| − | + | </syntaxhighlight> | |
If you wish to change the minimum duration of the tone: | If you wish to change the minimum duration of the tone: | ||
| − | + | <syntaxhighlight lang="text"> | |
rxbursttime=500 ;this would set the minimum time to 500ms | rxbursttime=500 ;this would set the minimum time to 500ms | ||
| − | + | </syntaxhighlight> | |
If you wish to change the minimum signal/noise ratio for the tone: | If you wish to change the minimum signal/noise ratio for the tone: | ||
| − | + | <syntaxhighlight lang="text"> | |
rxburstthreshold=10 ;this would set the minimum s/n quality to 10db | rxburstthreshold=10 ;this would set the minimum s/n quality to 10db | ||
| + | </syntaxhighlight> | ||
Latest revision as of 05:51, 6 September 2021
Setting Up Receive Toneburst Access (Europe mainly)
If you wish to set up a node to require receive toneburst (typically 1750 Hz, in Europe), you must, at least specify the toneburst frequency:
(The following parameters go into rpt.conf in the section for the desired node)
rxburstfreq=1750
If you wish to change the minimum duration of the tone:
rxbursttime=500 ;this would set the minimum time to 500ms
If you wish to change the minimum signal/noise ratio for the tone:
rxburstthreshold=10 ;this would set the minimum s/n quality to 10db