Line 1: |
Line 1: |
| + | = Setting Up Receive Toneburst Access (Europe mainly) = |
| [[Category:How to]] | | [[Category:How to]] |
| + | |
| + | If you wish to set up a node to require receive toneburst (typically 1750 Hz, in Europe), you must, at least specify the toneburst frequency: |
| + | |
| + | (The following parameters go into rpt.conf in the section for the desired node) |
| + | |
| + | rxburstfreq=1750 |
| + | |
| + | If you wish to change the minimum duration of the tone: |
| + | |
| + | rxbursttime=500 ;this would set the minimum time to 500ms |
| + | |
| + | If you wish to change the minimum signal/noise ratio for the tone: |
| + | |
| + | rxburstthreshold=10 ;this would set the minimum s/n quality to 10db |