PTTLink Standard Commands

This section contains the suggested prefix digits, mandatory command codes, and suggested command codes for PTTLink.

Prefix Digit Suggestions

PrefixFunctions

*1 Disconnect Link

*2 Monitor Link

*3 Connect Link

*4 Command Mode

*5 Macros

*6 User Functions

*7 Connection Status/Functions

*8 User Functions

*9 User Functions

*0 User Functions

*A User Functions

*B User Functions

*C User Functions

*D User Functions

Mandatory Command Codes

These are the mandatory command codes which all PTTLink nodes must support to provide command code consistency to the users.

Command CodeDescription

*1nodeDisconnect Link

*2nodeConnect link in monitor mode

*3nodeConnect link in transcieve mode

*4nodeEnter command mode on a remote node

*70 Local connection status

*99 DTMF Phone Key (Assert PTT from Phone Portal)

Notes

1. node is an PTTLink node number
2. Node number zero (0) is shorthand for the last node operated on by a previous command
3. Monitor mode means listen to a node, but do not send any audio to it
4. Command mode means send all received DTMF digits to the node number specified (bypassing the local command decoder). Send # to exit command mode, and restore local command decoding.

Optional Command Codes

Command CodeDescription

*80 Force System ID

*81 Say System Time

*980 Say app_rpt software version

*75 Link Connect (Local Monitor Only)

*72 Last active node (system-wide)

*73 System-wide connection status

*71 Disconnect all links (macro)

*74 Reconnect all links (macro)