Setting Up Receive Toneburst Access (Europe mainly)

If you wish to set up a node to require receive toneburst (typically 1750 Hz, in Europe), you must, at least specify the toneburst frequency:

(The following parameters go into rpt.conf in the section for the desired node)

rxburstfreq=1750

If you wish to change the minimum duration of the tone:

rxbursttime=500 ;this would set the minimum time to 500ms

If you wish to change the minimum signal/noise ratio for the tone:

rxburstthreshold=10 ;this would set the minimum s/n quality to 10db

RX Toneburst