Difference between revisions of "Blacklist or whitelist"

From "PTTLink Wiki"
Jump to navigation Jump to search
Line 1: Line 1:
Occasionally it becomes necessary to limit connections to your node. The blacklist blocks a small number of nodes. The whitelist allows only listed notes to connect.  
+
Occasionally it becomes necessary to limit connections to your node. The blacklist blocks a small number of nodes. The whitelist allows only listed notes to connect. Outbound connections are not blocked.
  
 
It's very easy to manage both list with these Asterisk CLI commands:
 
It's very easy to manage both list with these Asterisk CLI commands:
Line 55: Line 55:
 
</pre>
 
</pre>
  
''Note'': Only one list can be used at a same time and it applies to all nodes on the server. Outbound connections are not blocked.  
+
''Note'': Only one list can be used at a same time and it applies to all nodes on the server.  
  
 
[[Category:How to]]
 
[[Category:How to]]
 
[[Category:Node Configuration]]
 
[[Category:Node Configuration]]

Revision as of 20:19, 15 October 2017

Occasionally it becomes necessary to limit connections to your node. The blacklist blocks a small number of nodes. The whitelist allows only listed notes to connect. Outbound connections are not blocked.

It's very easy to manage both list with these Asterisk CLI commands:

  • Blacklist
    • database put blacklist 1998 "any comment"
    • database del blacklist 1998
    • database show blacklist
  • Whitelist
    • database put whitelist 1000 "any comment"
    • database del whitelist 1000
    • database show whitelist
  • Both
    • database show

Blacklist Configuration

Add this to extensions.conf just below the [radio-secure] context.

[radio-secure]
...

; To add a node to the blacklist: 
; database put blacklist 1998 “any comment”
; to remove:
; database del blacklist 1998
; to list
; database show blacklist
 
[blacklist]
exten => _XXXX!,1,NoOp(${CALLERID(num)})
exten => _XXXX!,n,GotoIf($[${DB_EXISTS(blacklist/${CALLERID(num)})}]?blocked)
exten => _XXXX!,n,Goto(radio-secure,${EXTEN},1)
exten => _XXXX!,n(blocked),Hangup

[whitelist]
exten => _XXXX!,1,NoOp(${CALLERID(num)})
exten => _XXXX!,n,NoOp(${IAXPEER(CURRENTCHANNEL)})
exten => _XXXX!,n,GotoIf($["${IAXPEER(CURRENTCHANNEL)}" = "127.0.0.1"]?radio-secure,${EXTEN},1)  ;permit local IPs
exten => _XXXX!,n,GotoIf($[${DB_EXISTS(whitelist/${CALLERID(num)})}]?radio-secure,${EXTEN},1)
exten => _XXXX!,n,Hangup

In iax.conf modify the [radio] context by adding and/or commenting context = lines.

[radio]
type = user
disallow = all
allow = ulaw
allow = adpcm
allow = gsm
codecpriority = host
;context = radio-secure
;context = whitelist
context = blacklist
transfer = no

Note: Only one list can be used at a same time and it applies to all nodes on the server.