Difference between revisions of "PTTLink Standard Commands"

From "PTTLink Wiki"
Jump to navigation Jump to search
m
Tag: visualeditor
Line 57: Line 57:
 
== Optional Command Codes ==
 
== Optional Command Codes ==
 
Command CodeDescription
 
Command CodeDescription
<nowiki>*</nowiki>80Force System ID
 
  
<nowiki>*</nowiki>81Say System Time
+
<nowiki>*</nowiki>80 Force System ID
  
<nowiki>*</nowiki>980Say app_rpt software version
+
<nowiki>*</nowiki>81 Say System Time
  
<nowiki>*</nowiki>75Link Connect (Local Monitor Only)
+
<nowiki>*</nowiki>980 Say app_rpt software version
  
<nowiki>*</nowiki>72Last active node (system-wide)
+
<nowiki>*</nowiki>75 Link Connect (Local Monitor Only)
  
<nowiki>*</nowiki>73System-wide connection status
+
<nowiki>*</nowiki>72 Last active node (system-wide)
  
<nowiki>*</nowiki>71Disconnect all links (macro)
+
<nowiki>*</nowiki>73 System-wide connection status
  
<nowiki>*</nowiki>74Reconnect all links (macro)
+
<nowiki>*</nowiki>71 Disconnect all links (macro)
 +
 
 +
<nowiki>*</nowiki>74 Reconnect all links (macro)

Revision as of 18:44, 20 November 2020

This section contains the suggested prefix digits, mandatory command codes, and suggested command codes for Allstar Link.

Prefix Digit Suggestions

PrefixFunctions

*1Disconnect Link

*2Monitor Link

*3Connect Link

*4Command Mode

*5Macros

*6User Functions

*7Connection Status/Functions

*8User Functions

*9User Functions

*0User Functions

*AUser Functions

*BUser Functions

*CUser Functions

*DUser Functions

Mandatory Command Codes

These are the mandatory command codes which all Allstar Link nodes must support to provide command code consistency to the users. Command CodeDescription

*1nodeDisconnect Link

*2nodeConnect link in monitor mode

*3nodeConnect link in transcieve mode

*4nodeEnter command mode on a remote node

*70Local connection status

*99DTMF Phone Key (Assert PTT from Phone Portal)

Notes

  1. node is an Allstar Link node number
  2. Node number zero (0) is shorthand for the last node operated on by a previous command
  3. Monitor mode means listen to a node, but do not send any audio to it
  4. Command mode means send all received DTMF digits to the node number specified (bypassing the local command decoder). Send # to exit command mode, and restore local command decoding.

Optional Command Codes

Command CodeDescription

*80 Force System ID

*81 Say System Time

*980 Say app_rpt software version

*75 Link Connect (Local Monitor Only)

*72 Last active node (system-wide)

*73 System-wide connection status

*71 Disconnect all links (macro)

*74 Reconnect all links (macro)