Line 1: |
Line 1: |
− | [[Category:URI]] | + | #REDIRECT [[URI]] |
− | URI Test (Loopback) connector
| |
− | | |
− | 25 pin male D-shell connector
| |
− | | |
− | Pin 1 to Pin 7
| |
− | | |
− | Pin 2 to Pin 3
| |
− | | |
− | Pin 4 to Pin 8
| |
− | | |
− | Pin 11 to Pin 24
| |
− | | |
− | Pin 14 to EEProm Pin 8
| |
− | | |
− | Pin 15 to EEProm Pin 1
| |
− | | |
− | Pin 16 to EEProm Pin 2
| |
− | | |
− | Pin 17 to EEProm Pin 3
| |
− | | |
− | Pin 18 to EEProm Pin 4
| |
− | | |
− | Pin 19 to EEprom Pin 5
| |
− | | |
− | 10K Resistor between Pins 21 & 22
| |
− | | |
− | 10K Resistor between Pins 21 & 23
| |
− | | |
− | For URIx P/N 9095 that uses the CM119A also include the following:
| |
− | | |
− | Pin 5 to Pin 10
| |
− | | |
− | Pin 6 to Pin 11
| |
− | | |
− | Do *NOT* include these connections for the older URI P/N 9080 that uses the CM108.
| |
− | | |
− | Remove EEprom pins 6 and 7 (not used).
| |
− | | |
− | Use an ATMEL AT93C46E-PU (Digikey Part Number AT93C46E-PU-ND)
| |
− | | |
− | or equiv. for the EEProm.
| |
− | | |
− | To accomplish this, pins 1 thru 4 of the the 8 pin DIP EEProm are soldered
| |
− | | |
− | directly to pins 15 thru 18 (1 to 15, 2 to 16, 3 to 17, 4 to 18) of the
| |
− | | |
− | 25 pin D-shell connector. Pin 14 is wired to pin 8 (Vcc) and pin 19 is
| |
− | | |
− | wired to pin 5 (Gnd) of the EEProm. Pins 6 and 7 of the EEProm are not
| |
− | | |
− | used and may be removed.
| |